Description

Explaination: MTU configuration missing for Jumbo frames


 


Physical interface: et-0/0/5, Enabled, Physical link is Down

Interface index: 1255, SNMP ifIndex: 529, Generation: 562640717185

 Link-level type: Ethernet, MTU: 1514, LAN-PHY mode, Speed: 100Gbps, BPDU Error: None, Loop Detect PDU Error: None, Ethernet-Switching Error: None, MAC-REWRITE Error: None, Loopback: Disabled, Source filtering: Disabled, Flow control: Enabled, Auto-negotiation: Disabled, Media type: Fiber


 Device flags : Present Running Transceiver-Absent


 Interface flags: Hardware-Down SNMP-Traps Internal: 0x8000


 CoS queues  : 8 supported, 8 maximum usable queues


 Hold-times  : Up 0 ms, Down 0 ms


 Damping    : half-life: 0 sec, max-suppress: 0 sec, reuse: 0, suppress: 0, state: unsuppressed


 Current address: 20:93:39:e4:6a:b2, Hardware address: 20:93:39:e4:6a:b2


 Last flapped : 2024-12-25 20:29:03 UTC (00:10:40 ago)


 Statistics last cleared: Never

Symptoms

epp.epe.cfg.elu.trapcode.df_set_for_fragmentation trapcode increments under >show cda trapstats

Solution

Re-check if interfaces in question are configured with correct MTU (mostly Jumbo frames)

Modification History

2025-01-16 : Article Created