Description

While setting up a Blueprint (Blueprint -> Staged -> Physical -> Selection -> S/N), I'm noticing that the GUI does not show any S/N in the drop down eventhough they are listed in "managed devices" page. I'm looking for advice on what may be the possible issue on why this number is not showing up in the Blueprint. The devices in managed devices are all in OOS-READY state, Acknowledged, and in Full Control Operation mode. I am able to see that Apstra is picking up the serial number from this page.

Solution

There are some possible causes for this

1) Please check if the device has been ACK'd in managed devices. If not, please ACK the device. 

2) Please check if the device profile for the device matches the device profile on your blueprint. If they are not matched, you may need to fix the device profile for your managed device or create a new interface map with a proper device profile for your blueprint. 

For the latter case, once IMs are created, then you can import them to the blueprint and use them. 

Create Interface Map: 
https://www.juniper.net/documentation/us/en/software/apstra6.1/apstra-user-guide/topics/task/interface-map-create.html

Import Interface Map:
https://www.juniper.net/documentation/us/en/software/apstra6.1/apstra-user-guide/topics/task/interface-map-import.html
 

Modification History

2024-07-10 : Article Created

2026-02-09: Docs link updated 4.2 -> 6.1