The minimum configuration required to run FAN's at Full speed on PTX10001-36MR

While inserting the 400g optics on to the PTX10001-36MR, its recommended to run the FAN's at full speed.

To run the FAN's at full speed, please use the below sensor config on PTX10001-36MR at the following hierarchy

root@jtac-PTX10001-36MR# set chassis cb 0 temperature-sensor ?   

Possible completions:

 <name>        Temperature sensor name

 Temp Sensor PSM Inlet Temperature sensor name <<<<<< sensor name

[edit]

root@jtac-PTX10001-36MR# set chassis cb 0 temperature-sensor       

temperature-sensor "Temp Sensor PSM Inlet" { <<<<<<<<< sensor name is Temp Sensor PSM Inle

   temperature-threshold {

       fans-on-full-speed 30;

       fans-on-full-speed-if-failed-fan 28;

       fans-on-intermediate-speed 20;

       fans-to-normal-speed 15;

       fire-shutdown 80;

       red-alarm 75;

       red-alarm-if-failed-fan 72;

       yellow-alarm 65;

       yellow-alarm-if-failed-fan 62;

   }

}