This article clarifies the platforms supported and points to the technical documentation that provides an overview with configuration examples. For other topics, go to the SRX Getting Started main page.
This section contains the following topics:
Dynamic IPSec VPN is supported on the following devices (by default, a two user evaluation license is provided free of cost and it does not expire. If more than two users need to connect concurrently, a license is required. For license ordering information, refer to the following datasheet: http://www.juniper.net/us/en/local/pdf/datasheets/1000281-en.pdf . For more information on license usage, refer to KB17292 - Check license usage & install license [juniper.net] ):
To information about the minimum Dynamic VPN requirements for the client and SRX device refer to KB17436 [Dynamic VPN] Minimum requirements for client and SRX device [juniper.net] . For J-Series devices, use NetScreen-Remote to configure a Remote Access IP/Sec VPN. For more information, refer to KB10128 - How to configure IPSec VPN on a J Series or SRX Series device. [juniper.net]
For step-by-step configuration instructions, refer to the TN7 - Configuring Dynamic VPN application note. The Junos Pulse client is automatically downloaded in Junos. However, if you need to manually install the Junos Pulse client, refer to KB17641 - Using Junos Pulse to connect Dynamic VPN client to SRX [juniper.net] .
For troubleshooting, refer to KB17220 - [Dynamic VPN] Troubleshoot Dynamic VPN client that is not working [juniper.net] .